Subscribe RSS

Archive for 2019

CR-10 X Axis Issue Nov 10

Spent along time trying to work out why my CR-10 printer was not working after I moved it. First issue was leveling and that fixed a few issues but the printer still seemed to lose the plot on the 100th layer.

Anyway I moved it to a new location in my office a did a full table leveling. Worked great first level stuck, but there was a bad x Axis issue after a while and it got worse after the move. Firstly I tried a full tighten up of all screws and bolts but did not work.

Seem the X was still out badling. Next did a full tighten up with a screwdriver pusing the x axis out. Nope. Next attempt was pull the right end apart and put together with just finger pressure to tighten up while making sure it was eye level level. And wow, we are back on track for good prints.

Category: Uncategorized  | Comments off